bcm43xx firmware

po zakupie nowego lapa (DELL Vostro 1500) przyszła pora na wyrzucenie domyślnie zainstalowanej visty home i zainstalowanie PLD.
mały problem z WiFi został szybko rozwiązany specami autorstwa arekm.

dzięki temu uruchomienie całości zprowadza się do:
– zbudowania bcm43xx-fwcutter.spec
– zainstalowanie powyższego
– zbudowania bcm43xx-firmware.spec
– zainstalowania powyższego
– usunięcia bcm43xx (jeśli udev już go wrzucił)
– załadowania bcm43xx

karta wifi:
0c:00.0 Network controller: Broadcom Corporation BCM94311MCG wlan mini-PCI (rev 01)
dmesg po załadowaniu drivera i podniesieniu sieci zeznaje:
bcm43xx: Chip ID 0x4311, rev 0x1
bcm43xx: Number of cores: 4
bcm43xx: Core 0: ID 0x800, rev 0x11, vendor 0x4243
bcm43xx: Core 1: ID 0x812, rev 0xa, vendor 0x4243
bcm43xx: Core 2: ID 0x817, rev 0x3, vendor 0x4243
bcm43xx: Core 3: ID 0x820, rev 0x1, vendor 0x4243
bcm43xx: PHY connected
bcm43xx: Detected PHY: Analog: 4, Type 2, Revision 8
bcm43xx: Detected Radio: ID: 2205017f (Manuf: 17f Ver: 2050 Rev: 2)
bcm43xx: Radio turned off
bcm43xx: Radio turned off
Device driver eth1 lacks bus and class support for being resumed.
bcm43xx: PHY connected
Device driver 0000:0c:00.0 lacks bus and class support for being resumed.
Device driver 0000:0c:00.0 lacks bus and class support for being resumed.
Device driver 0000:0c:00.0 lacks bus and class support for being resumed.
Device driver 0000:0c:00.0 lacks bus and class support for being resumed.
bcm43xx: Microcode rev 0x127, pl 0xe (2005-04-18 02:36:27)
bcm43xx: Radio turned on
bcm43xx: Radio enabled by hardware
bcm43xx: Chip initialized
bcm43xx: 32-bit DMA initialized
bcm43xx: Keys cleared
bcm43xx: Selected 802.11 core (phytype 2)
ADDRCONF(NETDEV_UP): eth1: link is not ready
bcm43xx: set security called, .level = 0, .enabled = 0, .encrypt = 0
bcm43xx: set security called, .level = 0, .enabled = 0, .encrypt = 0
bcm43xx: set security called, .level = 0, .enabled = 0, .encrypt = 0
bcm43xx: set security called, .level = 0, .enabled = 0, .encrypt = 0
SoftMAC: Open Authentication completed with xx:xx:xx:xx:xx:xx
ADDRCONF(NETDEV_CHANGE): eth1: link becomes ready
bcm43xx: set security called, .active_key = 0, .level = 2, .enabled = 1, .encrypt = 1
bcm43xx: set security called, .enabled = 1, .encrypt = 1
eth1: no IPv6 routers present